Filter
Top Products
124
US
D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF
06\4420297142_US\US07ADD_STR-DN1030-CEL.fm
masterpage: Left
STR-DN1030
4-420-297-14(2)
You cannot connect the receiver to a
service.
• Make sure that the wireless LAN router/
access point is turned on.
• Check the network status. See “To check
the network information” (page 99), then
select “Connection” in step 2. If
“Connection Fail” appears, set up the
network connection again (page 66).
• When the system is connected to the
wireless network, move the receiver and
the wireless LAN router/access point
closer to each other.
• If your contract with your Internet
provider limits Internet connection to one
device at a time, this device will not be
able to access the Internet when another
device is already connected. Consult your
carrier or service provider.
The sound skips.
• The bandwidth of your wireless LAN may
be too low. Move the receiver and the
wireless LAN router/access point closer to
each other, without any obstacles between.
Pairing cannot be done.
• Move the Bluetooth device closer to the
receiver.
• Pairing may not be possible if other
Bluetooth devices are present around the
receiver. In this case, turn off the other
Bluetooth devices.
• Enter the same passkey that was entered at
the Bluetooth device correctly (page 82).
Cannot make the Bluetooth
connection.
• The Bluetooth device you attempted to
connect does not support the A2DP
profile, and cannot be connected with the
receiver.
• Press BLUETOOTH on the receiver to
connect to the last connected Bluetooth
device.
• Turn on the Bluetooth function of the
Bluetooth device.
• Establish a connection from the Bluetooth
device.
• The pairing registration information has
been erased. Perform the pairing operation
again (page 82).
• While connected to a Bluetooth device,
this receiver cannot be detected and a
connection cannot be established from
another Bluetooth device.
• Erase the pairing registration information
of a Bluetooth device (page 101) and
perform the pairing operation again.
The sound skips or fluctuates, or the
connection is lost.
• The receiver and the Bluetooth device are
too far apart.
• If there are obstacles between the receiver
and your Bluetooth device, remove or
avoid the obstacles.
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device, or a
microwave oven nearby, move them
away.
The sound of your Bluetooth device
cannot be heard on this receiver.
• Turn up the volume on your Bluetooth
device first, and then adjust the volume
using MASTER VOL + or
2 + (or
MASTER VOLUME on the receiver).
Severe hum or noise
• If there are obstacles between the receiver
and your Bluetooth device, remove or
avoid the obstacles.
SEN
Bluetooth device