Filter
Top Products
masterpage:Left
lename[E:\SEM_Janet\Data_STR-
D
E697_revised\J9040016_4252272312DE697GB\4252272312\GB08REM_STR-DE697-
C
EL.fm]
46
GB
model name1[STR-DE697]
[4-252-272-31(2)]
If the factory settings of the INPUT SELECTOR
buttons do not match your system components,
you can change them. For example, if you have
an MD deck and a tape deck and you do not have
a CD player, you can assign the SA-CD button
to your tape deck.
Note that the settings of the TUNER button
cannot be changed.
1 Hold down the INPUT SELECTOR
button whose input you want to change
(for example, SA-CD).
2 Press the corresponding button of the
component you want to assign to the
INPUT SELECTOR button (for example,
6 – Tape deck).
The following buttons are assigned to select
the input:
*Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the SA-CD button to
control the tape deck.
To change the factory settings of
VIDEO 3 and AUX buttons
1 Hold down FN SHIFT and the INPUT
SELECTOR button you want to change
(for example, VIDEO 3 or AUX).
2 Press the corresponding button of the
component you want to assign to the
INPUT SELECTOR button.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the INPUT SELECTOR
buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the
same time.
Changing the factory
setting of an INPUT
SELECTOR button
To operate Press
CD player 4
MD deck 5
Tape deck A 6
Tape deck B 7
LD player 8
VCR (command mode VTR 1*) 9
VCR (command mode VTR 2*) 0
VCR (command mode VTR 3*) >10
TV ENTER
DSS (Digital Satellite Receiver) .
DVD player >
GB01COV_STR-DE697-CEL.book Page 46 Friday, April 2, 2004 12:21 PM