Filter
Top Products
48
GB
STR-DE695 4-244-559-11 (1)GB
Notes
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• Press MAIN MENU on the remote before you use
the V/v/B/b buttons for receiver operation.
• Press TOP MENU/GUIDE or AV MENU on the
remote before you use the remote to control the
satellite tuner, VCR and DVD player.
• The TV/SAT, PHONO, SOURCE, DIRECT, AAC
BI-LING, 12 and ON SCREEN functions are not
available for set operation.
Selecting the command
mode of the remote
Set the remote command mode using the USE
MODE button and the remote command mode
buttons.
Selecting the command mode
You can switch the command mode (AV1 or
AV2) of the remote. If the command mode of
the receiver and the remote is different, you
cannot use the remote to operate the receiver.
Press AV1 or AV2 while pressing down
USE MODE.
The indicator lights once (twice for AV2) , then
the command mode switches.
To check the command mode of the
remote
Press USE MODE. You can check the remote
by the indicator.
Mode Indicator lights
AV1 once
AV2 twice
Remote Button Description
(continued)
To reset the remote to factory
settings
Press =/1, AV =/1, and MASTER VOL – at
the same time.
The indicator lights 3 times, then goes off.
Programming the remote
You can program the remote to control non-
Sony components by changing the code. Once
the control signals have been memorized, you
can use those components as part of your
system.
Furthermore, you can also program the remote
for Sony components that the remote is unable
to control. Note that the remote can only
control components that accept infrared
wireless control signals.
1 Press AV ?/1 while pressing down USE
MODE.
The indicator lights.
2 Press the input selector button
(including TV ?/1) for the component
you want to control.
For example, if you are going to control a
CD player, press CD/SACD.
3 Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables on pages 49–51 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
4 Press ENTER.
Once the numeric code has been verified,
the indicator slowly flashes twice and the
remote automatically exits the programming
mode.