Filter
Top Products
4
GB
About This Manual
The instructions in this manual is for model
STR-DE485. Check your model number by looking at
the lower right corner of the front panel.
Tip
The instructions in this manual describe the controls
on the receiver. You can also use the controls on the
supplied remote if they have the same or similar
names as those on the receiver. For details on the use
of your remote, see pages 34 – 37.
Demonstration Mode
The demonstration will activate the first time you
turn on the power. When the demonstration
starts, the following message appears in the
display:
“NOW DEMONSTRATION MODE IF
YOU FINISH DEMONSTRATION
PLEASE PRESS POWER KEY WHILE
THIS MESSAGE APPEARS IN THE
DISPLAY THANK YOU”
To cancel the demonstration
Press ?/1 to turn the receiver off while the
above message is being displayed. The next time
you turn the receiver on, the demonstration will
not appear.
To view the demonstration
Hold down SET UP and press ?/1 to turn on
the power.
Notes
• Running the demonstration will clear the
receiver’s memory. For details on what will be
cleared, see “Clearing the receiver's memory”
on page 15.
• There will be no sound when the
demonstration mode is activated.
• You cannot cancel demonstration if you did
not press ?/1 while the above message is
being displayed. To cancel demonstration after
the above message appears, press ?/1 twice to
activate the demonstration again. Then, press
?/1 while the above message is being
displayed.
01GB02TOCCEL.p65 4/15/02, 5:01 PM4