Filter
Top Products
6
EN
FRONT SPEAKERS
B
RL
A
RL
Hookups
The arrow ç indicates signal flow.
CD player
Tape deck
DAT/MD
Turntable
• If your turntable has an earth lead
To prevent hum, connect the earth lead to the y ground
terminal on the receiver.
Where do I go next?
Go on to the next section to connect the speakers.
Getting Started
Tape deckReceiver
Receiver
L
R
CD
IN
OUTPUT
LINE
L
R
CD player
DAT/MDReceiver
Receiver Turntable
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response.
For specific locations of the terminals, see the
illustration below.
For optimum surround sound effect, place your
speakers as shown below.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Hookups
Front speakers
(+)
(+)
(–)
(–)
Front speaker
(R)
Front speaker
(L)
Receiver
} ]} ]
45°
Rear speaker
60 - 90 cm
Front speaker
FRONT SPEAKERS A
IMPEDANCE
SELECTOR
REAR
SPEAKERS
CENTER
SPEAKER
WOOFER
L
R
TAPE
INREC OUT
OUTPUT
LINELINE
L
R
INPUT
L
R
DAT/MD
INREC OUT
OUTPUT
LINELINE
L
R
INPUT
L
R
PHONO
IN
OUTPUT
LINE
L
R