Sony STR-DG520 Stereo System User Manual


 
64
GB
There is no sound from one of the front
speakers.
Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
There is no sound from digital sources
(from OPTICAL input jack) when
selecting SAT input.
Check that the INPUT MODE is not set to
“ANALOG” (page 55).
Check that ANALOG DIRECT is not set
to on.
The left and right sounds are
unbalanced or reversed.
Check that the speakers and components
are connected correctly and securely.
Adjust the balance parameters using the
LEVEL menu.
“UNLOCK” appears on the display.
• Check that your component is connected
to the COAXIAL or OPTICAL jack. If no
signal is input through the COAXIAL or
OPTICAL jack, “UNLOCK” appears on
the display and this is not a malfunction.
There is severe hum or noise.
Check that the speakers and components
are connected securely.
Check that the connecting cords are away
from a transformer or motor, and at least
3 m away from a TV set or fluorescent
light.
Move your audio components away from
the TV.
The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There is no sound, or only a very low-
level sound is heard from the center/
surround speakers.
Select a CINEMA STUDIO EX mode
(page 47).
Adjust the speaker level (page 30).
Make sure the center/surround speakers
are set to either “SMALL” or “LARGE”
(page 36).
There is no sound from the sub woofer.
Check that the sub woofer is connected
correctly and securely.
Make sure you have turned on your sub
woofer.
Make sure the sub woofer is set to “YES”
(page 36).
There is no sound from the sub woofer
depending on the sound field.
There is no sound from the component
connected to the DIGITAL MEDIA PORT
adapter.
Adjust the volume of this receiver.
The DIGITAL MEDIA PORT adapter
and/or component is not connected
correctly. Turn off the receiver, then
reconnect the DIGITAL MEDIA PORT
adapter and/or component.
Check the DIGITAL MEDIA PORT
adapter and/or component device to make
sure it supports this receiver.