Filter
Top Products
14
Listening to the sound
Check the following before operating the unit.
– If you have been listening to the sound from a Bluetooth stereo audio source device, terminate the
Bluetooth connection.
1 Press the 1 button to turn on this unit.
The power indicator (green) lights up.
2 Start playing on the source device.
3 Adjust the volume.
Set the volume of the source device to moderate level, and press the VOLUME +/–
buttons on this unit.
Note
A beep sounds when the volume is set to minimum or maximum.
4 Press and hold the 1 button to turn off this unit after using.
The power indicator goes off.
Notes
• If connecting the speaker to a device with a built-in radio or tuner, radio broadcasting cannot be received or
sensitivity may be reduced significantly.
• If the source device has a bass boost function or equalizer function, set them to off. If these functions are on,
sound may be distorted.
• If the source device’s headphone output has a line switch, better sound will be heard if it is set to on. See the
operating instructions of the source device.
• When the sound of a Bluetooth stereo audio device is being reproduced using the Bluetooth connection (when
both the power indicator (green) and communication status indicator (blue) light up), the sound from a device
connected to the INPUT jack cannot be heard. Terminate Bluetooth connection to listen to the sound of a device
connected to the INPUT jack.
1 button VOLUME +/– buttons