Filter
Top Products
22
US
7 Press ENTER to store the disc name.
Repeat Steps 1 through 7 to assign disc
names to other discs.
Other operations
Note
You cannot use the Disc Name when you play the disc
on other players.
On safety
• Caution – The use of optical instruments with this
product will increase eye hazard.
• Should any solid object or liquid fall into the cabinet,
unplug the player and have it checked by qualified
personnel before operating it any further.
• AC power cord must be changed only at the qualified
service shop.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
On power sources
• Before operating the player, check that the operating
voltage of the player is identical with your local
power supply. The operating voltage is indicated on
the nameplate at the rear of the player.
• The player is not disconnected from the mains as
long as it is attached to the mains, even if the player
itself has been turned off.
• If you are not going to use the player for a long time,
be sure to disconnect the player from the mains. To
disconnect the mains lead, grasp the plug itself; never
pull the cord.
On placement
• Place the player in a location with adequate
ventilation to prevent heat build-up in the player.
• Do not place the player on a soft surface such as a rug
that might block the ventilation holes on the bottom.
• Do not place the player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or mechanical shock.
On operation
• If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lenses inside the player. Should
this occur, the player may not operate properly. In
this case, remove the disc and leave the player turned
on for about an hour until the moisture evaporates.
• During power on, some noise may be heard while the
disc is being loaded into the Super Audio CD player.
This is not a malfunction.
On adjusting the volume
Do not turn up the volume too much while listening to
a portion with very low level inputs or no audio signals.
If you do, the speakers may be damaged when a peak
level portion is played.
To Do the following:
Correct a wrong
character
1 Press m/M repeatedly until
the incorrect character flashes.
2 Press CLEAR on the remote to
delete the incorrect character,
then input the correct character.
3 Press ENTER on the remote to
store the disc name.
Erase a disc name
1 Insert or select the disc you
want, then press NAME INPUT
on the remote.
2 Press CLEAR on the remote
repeatedly to delete all the
characters.
3 Press ENTER on the remote.
Erase all disc
names
1 Turn off the player.
2 While holding down x, press
POWER on the player.
After “ERASING” is displayed,
“ALL ERASE” appears in the
display and all disc names are
erased.
Additional Information
Precautions