Filter
Top Products
Operations Using the Remote (STR-DA7ES only)
73
GB
Notes
• If you do not press a button during step 2 through 4
within thirty seconds, the remote automatically exits
the button assignment mode. Start again from step
1.
• In step 3, if you press the same button more than the
possible number of categories that can be selected,
only the last category is registered for the new
assignment.
• In step 3, if you press several function buttons, the
category of the last pressed button is selected.
Valid buttons and the corresponding
categories
Categories*
Button 1st pressed 2nd pressed 3rd pressed
VIDEO1 VTR1 VTR4 —
VIDEO2 VTR2 VTR5 —
VIDEO3 VTR3 VTR6 —
DVD/LD DVD player LD player —
TV/SAT TV SAT —
TAPE Tape deck A Tape deck B —
MD/DAT MD deck DAT deck —
CD/SACD CD player 1 CD player 2 CD player 3
* To assign to VIDEO CD, press VIDEO 1 first, then
press CD/SACD.
To clear all remote button
assignments
Hold Down USE MODE, then press ?/1.
Advanced remote operations
When using a Sony receiver as an amplifier in
the 2nd (or 3rd) room, the following operations
are possible:
• Switching the output source for the 2ND (or
3RD) ROOM OUT jacks.
• Switching the Sony receiver’s power on or off
in the 2nd (or 3rd) room.
• Adjusting the volume of the Sony receiver in
the 2nd (or 3rd) room.
Notes
• This receiver has only 2 command modes (AV
SYSTEM 1 and AV SYSTEM 2). Therefore this
receiver shound only be used as an amplifier for one
additional soom (2nd or 3rd room). The first
command mode will be used for the main room, the
second can be used for either the 2nd or 3rd room.
• When using this remote in the 2nd (3rd) room, be
sure to set each receiver (main room and 2nd (3rd)
room) to a different command mode. The reason for
this is that if the command modes of the two
receivers are the same, the volume of the receiver in
the main room will increase when you raise the
volume in the 2nd (3rd) room.
continued