Filter
Top Products
22
GB
Additional Information
Troubleshooting
If you experience any of the following dif ficulties while
using the player , use this tr oubleshooting guide to help
you r emedy the pr oblem. Should any pr oblem persist,
consult your near est Sony dealer .
There is no sound.
, Check that the player is connected secur ely .
, Make sur e you operate the amplifier cor rectly .
There is no sound from the DIGITAL OUT CD
connectors.
, The audio signals of the super audio CD cannot be
output fr om the DIGIT AL OUT CD connectors.
, Press DIGIT AL OUT to display “16 bit” in the
display when the player is playing the CD.
The disc does not play.
, Ther e is no disc inside the player .
, Ther e is no stabilizer on the disc.
, The disc is placed upside down on the tray .
, Place the disc on the disc tray with the label side
up.
, The disc is placed at an angle. Reload the disc and
the stabilizer .
, Clean the disc (see page 21).
, Moistur e has condensed inside the player . Remove
the disc and leave the player turned on for about
an hour (see page 20).
, Ther e is an incompatible disc on the tray (see page
7).
, Clean the turntable (see page 21).
The remote does not function.
, Remove any obstacles in the path of the r emote
and the player .
, Point the r emote at the r emote sensor on the
player .
, If the batteries in the r emote ar e weak, r eplace
with new ones.
Specifications
When a super audio CD is played
Playing frequency range 2 Hz to 100 kHz
Frequency response 2 Hz to 50 kHz (–3 dB)
Dynamic range 105 dB or more
Total harmonic distortion rate
0.0012 % or less
Wow and flutter Value of measurable limit (±0.001 %
W. PEAK) or less
When a CD is played
Frequency response 2 Hz to 20 kHz
Dynamic range 100 dB or more
Total harmonic distortion rate
0.0017 % or less
Wow and flutter Value of measurable limit (±0.001 %
W. PEAK) or less
Output connector
*Output only the audio signals of the CD
General
Laser radiant power: 1.52uW at 780nm (for CD)
5.47uW at 650nm (for SACD)
*These output is the value measured at a distance of about
200mm from the objective lens surface on the optical pick-up.
Power requirements
European models: 230 V AC, 50/60 Hz
USA and Canadian models:
120 V AC, 60 Hz
Power consumption 36 W
Dimensions (w/h/d) 430 × 149 × 436 mm
(17 × 5
7
/8 × 17
1
/4 in.) incl. projecting
parts
Mass (approx.) 25 kg (55 lbs 2 oz.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Load impedance
ANALOG OUT
DIGITAL OUT
CD OPTICAL*
DIGITAL OUT
CD COAXIAL*
Phono
jacks
Jack type
2 Vrms
(at 50 kilohms)
Square
optical
output
connector
–18 dBm
0.5 Vp-p
Over 10 kilohms
Light emitting
wave length:
660 nm
Output level
75 ohms
Coaxial
output
connector
( )