Filter
Top Products
Additional Information
27
US
Symptom Cause and remedy
The DOLBY PRO
LOGIC II indicator
does not turn on
The DOLBY PRO
LOGIC II indicator
turns on
The DTS indicator
does not turn on
MPEG-2 AAC
indicator does not
light up.
The battery
cannot be
charged
The CHG indicator
blinks.
RF signal
transmission does
not stop. (when the
INPUT SELECT
switch on the
processor is set
to “ANALOG”)
,The EFFECT switch on the processor is set to “OFF.”
,Analog input signal, digital input PCM signal, Dolby Digital 2-channel signal
or MPEG-2 AAC 2-channel signal is not input.
,The EFFECT switch on the processor is set to “CINEMA” or “MUSIC” mode.
,Analog input signal, digital input PCM signal, Dolby Digital 2-channel signal
or MPEG-2 AAC 2-channel signal is input.
,The DTS digital output setting on the DVD device (including game machines)
is set to “OFF.”
• See the instruction manual of your DVD device, and change the DTS digital
output setting to “ON.”
,Playback signals are not recorded in DTS format.
,The audio for the chapter being played is not a DTS signal.
,The DVD device does not support DTS format.
• Use a DVD device that supports DTS.
,Playback signals are not recorded in MPEG-2 AAC format.
,Check if the CHG indicator turns on. If not, put the headphones on the
processor correctly so that the CHG indicator turns on.
,Dry batteries are installed.
• Insert the supplied rechargeable nickel-metal hydride battery.
,Rechargeable batteries other than the supplied are installed.
• Insert the supplied rechargeable nickel-metal hydride battery.
,The processor’s contact pin and headphones’ contact point are dusty.
• Wipe them with a cotton bud, etc.
,3 and # of the rechargeable battery do not match those in the battery
compartment correctly.
• Insert the rechargeable battery with correct polarity.
,The rechargeable battery is damaged.
• Replace it with a new one. The rechargeable battery, type BP-HP2000, is not
commercially available. You can order the battery from the store where you
purchased this system, or at your nearest Sony dealer.
,Signal noise is output from the connected analog component.
• Unplug the connected analog component, or set the INPUT SELECT switch
on the processor to "DIGITAL," and make sure playback of the component
connected to the DIGITAL IN jack is stopped.
(Continued)