Filter
Top Products
55
US
F:\Sony SEM
HA\Revision2_DDW700\J906XXXX_26614591212DDW700_US\2661459122\050AMP_HT-
DDW700_UCA.fm
masterpage: Right
HT-DDW700
2-661-459-12 (2)
Additional Information
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 19). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 85 watts per channel
minimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
1)
Models of area code U
(6 ohms 1 kHz, THD 10%)
FRONT
2)
: 133 W/ch
CENTER
2)
: 133 W
SUR
2)
: 133 W/ch
(6 ohms 100 Hz, THD 10%)
SUB WOOFER
2)
: 135 W
Models of area code CA
(6 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 85 W/ch
CENTER
2)
: 85 W
SUR
2)
: 85 W/ch
(6 ohms 100 Hz, THD 0.7%)
SUB WOOFER
2)
: 85 W
(6 ohms 1 kHz, THD 10%)
FRONT
2)
: 133 W/ch
CENTER
2)
: 133 W
SUR
2)
: 133 W/ch
(6 ohms 100 Hz, THD 10%)
SUB WOOFER
2)
: 135 W
1) Measured under the following conditions:
2) Depending on the sound field settings and the
source, there may be no sound output.
To clear See
All memorized settings page 19
Customized sound fields page 42
Area code Power requirements
U, CA 120 V AC, 60 Hz
continued
010COV_HT-DDW700_UCA.book Page 55 Friday, January 13, 2006 3:36 PM