Filter
Top Products
CD
9
Programing the CD tracks
— Program Play
You can make a program of up to 28 tracks in
the order you want them to be played.
1 Press CD (CD/REMAIN on the remote),
then place a CD.
2 Press ENTER/PGM (TUNER MEM/
ENTER/PGM on the remote) repeatedly
until “00 PR.01” appears in the display.
3 Press . m or M > until the
desired track appears in the display.
4 Press ENTER/PGM (TUNER MEM/
ENTER/PGM on the remote).
The track is programed. The next program
step number appears, and “PROGRAM”
flashes.
5 To program additional tracks, repeat
steps 3 to 4.
6 Press u.
Program Play starts.
Programed step number
To
Check the total
number of
programed
tracks
Cancel Program
Play
Tip
The program you made remains after Program Play
finishes. When Program Play remains in the system’s
memory, “PROGRAM” flashes. To play the same
program again, press CD (CD/REMAIN on the
remote) and ENTER/PGM (TUNER MEM/ENTER/
PGM on the remote), then press u.
Using the CD display
Press REMAIN (CD/REMAIN on the
remote) repeatedly.
The display changes as follows:
During normal play
Elapsed playing time on the current track t
Remaining time on the current track t
Remaining time on the current CD t
Elapsed playing time on the current track t ...
Selected track number
(including selected track)
Do this
Press ENTER/PGM (TUNER
MEM/ENTER/PGM on the remote)
repeatedly in stop mode. Each time
you press the button, the selected
track number and the programed
step number appear in the display
in turn.
Press x twice until “PROGRAM”
disappears from the display. The
program you made will be erased.