Filter
Top Products
42
Tape Player
The tape does not move when you press
an operation button.
• Insert the tape properly and close the tape
compartment securely.
The REC button does not function/The
tape does not play.
• Make sure the safety tab of the tape in the
tape compartment is in place. If not, “No
Tab” will be displayed.
• Press FUNCTION to switch the function of
the player to “TAPE”.
The tape does not erase completely.
• Clean the erasing heads (see page 43).
• The source which was recorded on TYPE II
(high position) or TYPE IV (metal) tape is
being played. Record on TYPE I (normal)
tape and play.
The tape does not record.
• Make sure the tape is inserted properly. If
not, “No Tape” will be displayed.
• Make sure the safety tab of the tape in the
tape compartment is in place. If not, “No
Tab” will be displayed.
The audio is weak/The audio quality is
poor.
• Clean the heads, pinch rollers and capstans
(See page 43).
• Demagnetize the heads using a demagnetizer
(see page 43).
The tape player cannot be paused during
playback.
• The tape player can be paused during
recording only.
Timer
The timer does not operate.
• Make sure the time on the clock is correct.
• Check to see if the AC power had been cut
off.
• Make sure the tape has not wound to the end.
• Make sure the (clock) indicator is
displayed.
Remote
The remote does not function.
• Replace all the batteries in the remote with
new ones if they are weak.
• Make sure that you are pointing the remote at
the remote sensor on the player.
• Remove any obstacles in the path of the
remote and the player.
• Make sure the remote sensor is not exposed
to strong light such as direct sunlight or
fluorescent lamp light.
• Move closer to the player when using the
remote.
After trying the above remedies, if you still have
problems, unplug the AC power cord. After all the
indications on the display disappear, plug the
power cord in again. If the problem persists,
please consult your nearest Sony dealer. In that
case, be sure to bring the left speaker which
contains the power section along with the main
unit (CMT-A70).
Troubleshooting
(continued)