Filter
Top Products
Playing CDs
11
GB
Programming the CD
tracks
You can arrange the order of the tracks on the
discs and create your own programme. The
programme can contain up to 32 “steps” — one
“step” may contain a track or a whole disc.
1 Press PLAY MODE repeatedly until
“PROGRAM” appears in the display
before you start playing.
If a programme is already stored, the last
step of the programme appears in the
display. When you want to erase the whole
programme, hold down CLEAR until “ALL
CLr” appears in the display (see page 12).
2 Press DISC 1 – 5 to select the disc.
“AL” in the display stands for “all” tracks.
When you want to programme the whole
disc as one step, skip Step 3, and go to Step
4.
3 Turn lAMSL until the track you
want appears and push lAMSL to
select the track.
The track number that you programmed, the
playing order, and the total playing time
appear in the display.
If you’ve made a mistake
Press CLEAR, then repeat Step 2.
4 To programme other discs or tracks, do
the following:
5 Press H to start Programme Play.
To cancel Programme Play
Press PLAY MODE.
Tips
• You can create your programme while checking the
disc labels.
While the disc tray is open, follow Steps 1 to 4 with
pressing the DISC SKIP button to check the disc
labels. If you close the disc tray before Step 5, the
total playing time appears in the display after a
while.
Note that, if the programmed track number isn’t
found on the disc, that step is automatically erased.
• The programme remains even after the Programme
Play ends. When you press the H button, you can
play the same programme again.
• The programme remains until you erase it or turn
off the player. If you replace discs, the programmed
disc and track numbers remain. So, the player plays
only the existing disc and track numbers. However,
the disc and track numbers that aren’t found in the
player or on the disc are deleted from the
programme, and the rest of the programme is played
in the programmed order.
• For the recording to the A side or B side of the
cassette tape, you can pause Programme Play.
Note
The total playing time doesn’t appear when:
—You have programmed a track whose number
exceeds 20.
—The total playing time of the programme exceeds
200 minutes.
Checking the track order
You can check your programme before or after
you start playing.
Press CHECK.
Each time you press this button, the display
shows the track (the disc and track numbers) or
the disc (the disc number and “AL” indication)
of each step in the programmed order. After the
last step in the programme, the display shows
“End” and returns to the original display. If you
check the order after you start playing, the
display shows only the remaining steps.
To programme
Other discs
Other tracks on the
same disc
Other tracks on
other discs
Repeat Step(s)
2
3
2 and 3
continued