Filter
Top Products
11
Home Theater Operations
RESET
ADJUST +/–
TEST TONE
REAR
CENTER
BALANCE L/R
Changing the display
You can dim the display, or turn it off, according to
your preference.
Press DIMMER a few times until the display mode you
desire appears.
The display returns to full brightness temporarily
when you press one of the buttons on the control panel
or the remote.
Adjusting the Surround Sound
Although this speaker system is factory preset to
provide balanced surround sound without adjustment,
you can adjust the volume of each speaker and the
delay time to accommodate the conditions in your
living room or your individual preference.
Adjusting the speaker volumes
The test tone feature lets you adjust the volume of the
sound coming from each speaker to the same level, so
that the surround sound will be even and natural.
Make the following adjustments from your listening
position.
1 Choose the DOLBY SUR mode.
2 Press TEST TONE on the remote.
The test tone comes from each speaker in
sequence:
3 Adjust the volume levels so that you hear the test
tone from each speaker at the same volume level
when you are in your listening position:
4 Press TEST TONE on the remote to turn off the
test tone.
To restore the center,rear, or balance levels to the
factory setting
Press CENTER, REAR, or BALANCE L or R, then press
RESET.
Note
Pressing buttons other than MASTER VOL., RESET,
CENTER, REAR, or BALANCE L or R cancels the test tone.
Adjusting the delay time
By adjusting the delay time you can enhance the spatial
characteristics of the sound to obtain a theater-like
presence regardless of the size of your room. If the rear
speakers are close to your listening position, choose a
longer delay time.
You can adjust the settings individually for DOLBY
SUR, HALL, and SIMULATED.
1 Choose any surround mode.
2 Playback a program.
3 Press DELAY TIME on the remote once to display
the current delay time.
4 Press DELAY TIME a few times to choose the
delay time you prefer, either 15, 20, or 30 ms.
The factory setting is 20 ms.
To restore the delay time to the factory setting
Press DELAY TIME and then RESET.
Resetting an entire surround mode
Press the button for the surround mode you want to
reset (i.e., HALL) and then press RESET while the
name of the surround mode is being displayed.
All of the adjustments in that mode, including the bass
and treble (page 12), are reset to the factory settings.
DELAY TIME
To adjust the level
between the right and left
front speakers
of the center speaker
of the rear speaker
press
BALANCE L or R
CENTER, then press
ADJUST + or –
REAR, then press
ADJUST + or –
/ Left Front (L) / Center / Right Front (R)
Rear ?