Sony PS-LX250H Turntable User Manual


 
4
GB
SONY PS-LX250H 3-866-873-15 (1)
Assembling the Turntable
1
Set the EQ switch according to the jacks of your stereo
system (amplifier).
When your stereo system (amplifier) has PHONO
input jacks (connect to PHONO input jacks)
set to OFF.
When your stereo system (amplifier) does not have
PHONO input jacks (connect to AUX, VIDEO input
jacks, etc.)
set to ON.
2
Move the metallic parts inside the larger gear in the
direction of arrows.
When the power is supplied after assembling or
moving the turntable
The turntable sometimes rotates and the torn arm descends to
the platter even if START is not pressed.
If this occurs, press STOP to return the tone arm to the arm
stand.
3
Carefully, place the platter on the spindle.
4
Using the ribbon, loop the drive belt around the motor
pully. After looping the belt, do not forget to remove the
ribbon.
5
Place the rubber mat on the platter.
Getting Started
Installing the dust cover
Insert the hinges on the dust cover into the hinge pockets on
the rear of the cabinet.
Hooking up the Turntable
The phono cables come attached to the rear of the cabinet.
1
Connect the cable with the white plug to the white (L)
jack and connect the cable with the red plug to the red
(R) jack. Make sure to insert the plugs firmly into the
jacks. If the plugs are not inserted firmly, noise may be
occured.
Amplifier
L
R
It is necessary to set the EQ switch according to the
connected jacks. For details, refer to step 1 in
“Assembling the Turntable”.
Mains lead hookups
Connect the mains lead to an AC wall outlet after completing
all of the previous connections.
to a wall outlet
Note
Install this system so that the power cord can be unplugged
from the wall socket immediately in the event of trouble.