Filter
Top Products
49
4 Follow steps 3 to 5 of “Labeling a disc during stop”.
Labeling a track or a disc during recording
1 While recording, press ENTER (EDIT for 2 seconds or more).
2 Press <MENU, (flip the lever towards > or .)
repeatedly until “EDIT” flashes in the display, and then press
ENTER (ENTER) again.
“ :Name” flashes in the display.
3 To label a track, press ENTER (ENTER) again.
To label a disc, press <MENU, (flip the lever towards >
or .) repeatedly until “ :Name” flashes in the display,
then press ENTER (ENTER).
The track or disc is ready to be labeled.
4 Follow steps 3 to 5 of “Labeling a disc during stop”.
To cancel labeling
Press T MARK (T MARK).
Notes
• When the recording is stopped while labeling a track or a disc during
recording, or when the recording moves on to the next track while labeling a
track, the input at that point is entered automatically.
• “LP:” is automatically added at the beginning of track names for tracks
recorded in LP2 or LP4 mode.
Relabeling recordings
Follow the steps corresponding to the labeling method until the disc
or track is ready to be labeled. Enter a new character over the one you
want to change, then press ENTER (ENTER) for 2 seconds or more.
Notes
• You cannot relabel premastered MDs or label MDs that have not been
recorded.
• The recorder is able to display, but cannot label using Japanese “Katakana”
characters.
• The recorder cannot rewrite a disc or track name of more than 200 letters that
was created by another device.