Filter
Top Products
16
If the recording does not start
• Make sure the recorder is not locked (page 38).
• Make sure the MD is not record-protected (page 54).
• Premastered MDs cannot be recorded over.
For models supplied with the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
Notes
• If the power supply is disrupted (i.e. the battery is removed or becomes
exhausted or the AC power adaptor is disconnected) during a recording or
editing operation, or while “TOC Edit” appears in the display, then it will not
be possible to open the lid until power is restored.
• You can make a digital recording only from an optical type output.
• When recording from a portable CD player, set the CD player to pause, and
then do the recording procedure on the recorder.
• Note the following when recording from a portable CD player:
—Some portable CD players may not be capable of digital out unless
powered by the AC power.
—Connect the AC power adaptor to the portable CD player and use it on AC
power as the power source.
—Disable any anti-skip function (such as ESP*) on the portable CD player.
∗ Electronic Shock Protection
Remove the MD x and open the lid.
3)
(The lid does
not open while “TOC Edit”
flashing in the display.)
1)
By setting “REC-Posi” to “From End,” recording operations will always start
from the end of the previously recorded material (page 27).
2)
A track mark is added at the point where you press X again to resume
recording while pausing; thus the remainder of the track will be counted as a
new track.
3)
If you open the lid while “REC-Posi” is set to “From Here,” recording will
begin with the first track the next time you record. Check the point to start
recording on the display.
To Press