Filter
Top Products
CMT-HX5BT.GB.3-095-518-61(1)
16
GB
Pairing this system with a Bluetooth
device
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
device. Once a pairing operation is
performed, it does not need to be
performed again. If pairing is already
completed, proceed to “Playing music of
a Bluetooth device” (page 17).
1
Place the Bluetooth device to be
connected to this system within
1 meter of the system.
2
Select the Bluetooth function.
Press BLUETOOTH
on
the unit.
3
Operate the Bluetooth device
and perform the pairing
operation.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
When searching for this system with
the Bluetooth device, a list of the
devices found may appear in the
Bluetooth device display depending
on the type of Bluetooth device.
is system appears as “CMT-
HX5BT.”
When establishing a connection with
this system, select the audio prole
(A2DP, AVRCP) at the Bluetooth
device. If the Bluetooth device does
not support the AVRCP prole, you
cannot perform playback or other
operations with the system (page 17).
4
Enter the passcode.
Passcode entry may be required
depending on the type of Bluetooth
device.
When “PIN?” and a countdown
appear, enter the passcode at the
system as follows:
Press / and /
on the remote (or +/ and
/ on the unit)
to enter the same passcode that was
entered at the Bluetooth device, and
then press ENTER
.
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect”
Name of the Bluetooth
device
To cancel passcode entry partway
Press
.
Notes
“Passcode” may be called “Passkey,” “PIN
code,” “PIN number” or “Password,” etc.
depending on the device.
is system only supports numerical
passcodes up to 4 digits.
e pairing standby status of the system is
cancelled aer about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.