Filter
Top Products
1-7
MVE-8000A
PSW3 x 6
Power dummy panel
B3 x 5
Connecting cable
Connecting cable
Connecting cable
Cover panel
(Slot 2)
Cable holder
bracket
Cable holder
bracket
1-4-3. Installing the HK-PSU02
The HK-PSU02 is used after it is installed in the MVE-
8000A.
c
Before installing the HK-PSU02, be sure to turn off the
main power. If the HK-PSU02 is installed while the main
power is turned on, it can result in electrical shock or
damage to printed circuit boards.
Installation procedure
1. Remove the front door assembly of the MVE-8000A.
(Refer to Section 1-4-1.)
2. Remove the two screws (PSW3 x 6) fixing the power
dummy panel, and remove the power dummy panel.
n
Store the removed power dummy panel in a safe place.
5. Secure the cable holder bracket and the slot 2 cover
panel with the screws removed in step 3 as shown in
the figure.