Filter
Top Products
10
GB
Adjusting the sound
Slight adjustments to the system can enhance
your sound enjoyment.
Adjusting the
subwoofer
Operation panel on the subwoofer
1 Set MODE according to the program
source as follows:
Source MODE
DVD, LD, video cassette MOVIE
or other video source
MD, CD, cassette tape MUSIC
or other audio source
2 Rotate LEVEL to adjust the volume.
Set the volume level to best suit your
preference according to the program
source.
Notes
•Some amplifier functions for enhancing the sound
may cause distortion in the subwoofer. If such
distortion occurs, turn off those functions.
•To enjoy high-quality sound, do not turn the
subwoofer volume too high.
•To increase the bass sound from the subwoofer,
connect the system using “Hookup B” (see
page 5).
•The bass sound is enhanced in MOVIE mode
rather than in MUSIC mode. Therefore, if you
change the mode to MOVIE while listening to
some sources that do not include the bass sound,
you may not be able to get the effect.
Setting your amplifier
to enjoy movies
(SA-VE815ED only)
For the Dolby Digital (AC-3)
If your amplifier is connected internally or
externally with a Dolby Digital (AC-3)
processor, you should use the setup menus
for the amplifier to specify the parameters of
your speaker system.
See the table below for the proper settings.
For details on the setting procedure, refer to
the manual that was provided with your
amplifier.
When “Hookup A” is used
(Speaker setup menu)
For Set to
Front speakers SMALL
Center speaker SMALL
Rear speakers SMALL
Subwoofer ON (or YES)
(Other setup menu)
Menu Set to
LFE* MIX –10 dB
BASS BOOST** ON
* Low Frequency Effect
**A function that reinforces the bass sound
When “Hookup B” is used
(Speaker setup menu)
For Set to
Front speakers LARGE
Center speaker SMALL
Rear speakers SMALL
Subwoofer OFF (or NO)
(Other setup menu)
Menu Set to
LFE MIX –10 dB
BASS BOOST ON
LEVEL
MODE
MIN
ON/
STANDBY
MAX
MOVIE
MUSIC
POWER
LEVEL MODE