Filter
Top Products
10
To tune in a station with a weak
signal
Press TUNING (TUNING/CLOCK/TIMER on
the remote) + or – repeatedly in step 2 to tune
in the station manually.
To set another station to an existing
preset number
Start over from step 1. After step 3, press
PRESET + or – repeatedly to select the preset
number where you want to store the other
station and the press ENTER (TUNER MEM/
ENTER on the remote).
You can preset a new station in the selected
preset number.
To erase all preset stations
1 Press and hold TUNER MEM (TUNER
MEM/ENTER on the remote) until
“ERASE” and “PRESET” appear alternately.
2 Press ENTER (TUNER MEM/ENTER on
the remote).
All preset stations are cleared.
To change the AM tuning interval
(except for the European model)
Disconnect the power cord from the wall outlet
first, and then set the AM FREQ STEP switch
at the rear to 9 kHz or 10 kHz.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Tuner
Presetting radio stations
You can preset up to 30 stations.
1 Press TUNER (TUNER/BAND on the
remote) repeatedly to select FM or AM.
2 Press and hold TUNING (TUNING/
CLOCK/TIMER on the remote) + or –
until the frequency indication starts to
change, then release it.
Scanning stops automatically when the
system tunes in a station. “STEREO” (for a
stereo program) appears.
If it doesn’t stop automatically, press
TUNING (TUNING/CLOCK/TIMER on
the remote) + or – repeatedly to tune in a
station manually.
3 Press TUNER MEM (TUNER MEM/
ENTER on the remote).
A preset number appears in the display.
The stations are stored from preset number
1.
4 Press ENTER (TUNER MEM/ENTER on
the remote).
The station is stored.
5 Repeat steps 1 to 4 to store other
stations.
Preset number