Filter
Top Products
18
To tune in a station with a weak
signal
Press m or M repeatedly in step 2 to tune in
the station manually.
To set another station to an existing
preset number
Start over from step 1. After step 4, press
– . or > + repeatedly to select the preset
number you want to store the other station.
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Tuner
Presetting radio stations
You can preset up to 20 stations for FM and 10
stations for AM.
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press and hold m or M until the
frequency indication starts to change,
then release it.
Scanning stops automatically when the
system tunes in a station. “TUNED” and
“STEREO” (for a stereo program) appear.
3 Press MENU.
4 Press – . or > + (or . or >
on the remote) repeatedly until
“MEMORY” appears, then press
ENTER.
A preset number appears.
Preset number
5 Press – . or > + (or . or >
on the remote) repeatedly to select the
desired preset number.
6 Press ENTER.
“COMPLETE” appears.
The station is stored.
7 Repeat steps 1 to 6 to store other
stations.