Filter
Top Products
6
GB
Perform the following procedures 1 to 5 to hook up your system using the supplied cords and
accessories. Australian model is used for illustration purpose.
Preparation
Place the components as shown below.
1 Connect the system control cables to
the SYSTEM CONTROL connectors on
the tape deck.
Connect to the same numbered jack in the
order indicated on the rear panel.
Note
The system cable is used to send signals and electricity
between the components for interlinked operation.
Be sure to insert the connector horizontally until it
clicks into place. Otherwise the system will not operate
correctly.
2 Connect the speakers.
Connect the speaker cords to the
SPEAKER terminals on the tape deck and
to the terminals on the speakers as shown
below.
Speakers
Getting Started
Hooking up the system
AM loop antenna
Front
speaker (right)
Front
speaker (left)
FM lead antenna
CD player/
Tuner
Amplifier/
Tape deck
Amplifier/
Tape deck
CD player/
Tuner
R
L
S
PE
AKE
R
Gray (3)
Black (#)
Gray (3)
Black (#)