Filter
Top Products
45
Connecting audio
components
Select one of the following connections,
depending on the equipment to be connected
and method of connecting. Refer to the
instructions of each component.
Connecting an MD deck
for digital recording
You can record from CD into the MD deck
digitally by connecting an optical cable.
4 Set the time to start recording.
Turn the jog dial to set the hour, then
press ENTER/NEXT.
The minute indication starts flashing.
Turn the jog dial to set the minute, then
press ENTER/NEXT.
The hour indication flashes again.
5 Set the time to stop recording
following the above procedure.
The start time appears, followed by the
stop time, the preset radio station to be
recorded (e.g., “TUNER FM 5”), then the
original display appears.
6 Insert a recordable tape.
7 Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and turn the jog dial to
select “REC”, then press ENTER/NEXT.
To change the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and turn the jog dial to
select “TIMER OFF”, then press ENTER/
NEXT.
Note
If the power is on at the preset time, the recording
will not be made.
To the DIGITAL IN jack of the MD deck
Optional components
continued