Filter
Top Products
10
To Do this
Playing a CD (continued)
Switch to CD
function from
another source
3 Press one of DISC 1 – 3 to select a CD.
To program all the tracks on a CD at once,
proceed to step 5 with “AL” displayed.
4 Press . or > until the desired
track appears in the display.
Disc number
Total playing time
(including selected track)
Track number
5 Press ENTER.
The track is programed. The program step
number appears, followed by the total
playing time.
6 To program additional tracks, repeat
steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
7 Press nN.
To Do this
Cancel Program
Play
Clear a track from
the end
Press CLEAR on the remote in
stop mode.
Add a track to
the program in
stop mode
Do steps 3 to 5.
Clear the entire
program
Press x once in stop mode or
twice during play.
Press DISC 1 – 3 (Automatic
Source Selection). However, if a
CD is used in a program, play does
not start even if you press CD 1 –
3.
Remove a CD Press Z OPEN/CLOSE.
Exchange other
CDs while
playing
Press DISC SKIP EX-CHANGE.
Play repeatedly
(Repeat Play)
Press REPEAT during play until
“REPEAT ALL” or “REPEAT 1”
appears.
REPEAT ALL*: For all the tracks
on the CD up to five times.
REPEAT 1**: For a single track
only.
To cancel playing repeatedly, press
REPEAT until “REPEAT ALL” or
“REPEAT 1” disappears.
* You cannot select “REPEAT ALL” and
“SHUFFLE ALL DISCS” at the same time.
**When you select “REPEAT 1”, that track is
repeated endlessly until REPEAT 1 is canceled.
Note
The play mode cannot be changed while playing a
disc. To change the play mode, press x first to stop
play.
Programing CD tracks
–– Program Play
You can make a program of up to 32 tracks
from all the CDs in the order you want to play
them.
1 Press CD, then place a CD.
2 Press PLAY MODE repeatedly until
“PROGRAM” appears in the display.
Press PLAY MODE repeatedly
until “PROGRAM” and
“SHUFFLE” disappear.