Filter
Top Products
10
Sending RF signals from the transmitter
The transmitter starts sending RF signals
automatically when it detects an audio signal
from the equipment connected.
If it does not detect an audio signal for more than
about four minutes, the transmitter will stop
sending RF signals, and the power indicator will
turn off.
When the transmitter receives an audio signal
again, it starts sending the RF signals, and the
power indicator will light in red again.
If the audio signal is very weak, the transmitter
does not send RF signals. If the transmitter is
connected to a headphone jack, make sure the
volume of the equipment connected is set to 5 – 6
or higher.
You may not hear the beginning of the sound
from the headphones until the transmitter starts
sending the RF signals after detecting an audio
signal.
The headphones automatically turn
off when they are taken off
— Auto power on/off function
Do not pull up the self-adjusting band when not
in use, as this will consume the battery power.
Notes
•If hiss is heard, move closer to the transmitter.
•You may hear some noise when you disconnect the
AC power adaptor from the transmitter before taking
off the headphones.
Using the vibration function
Set the VIBRATION switch to ON and adjust the
level of vibration using the vibration volume.
You can enjoy powerful bass sound when you
listen to movies or games through the
headphones.
Using SRS surround function
Set the switch to ON to reproduce a wide
surround sound field through the headphones.