Filter
Top Products
38
GB
To set the Recording Timer using the
controls on the unit (REC TIMER)
1 Tune in the preset station
(page 34).
2 Press REC TIMER.
“ON” appears, and the hour indication
flashes.
3 Turn OPERATION DIAL to set the
hour, then press ENTER.
The minute indication flashes. Use the
procedure above to set the minutes.
4 Use the same procedure as in step
3 to set the time to stop recording.
The display shows the timer settings.
5 Connect a transferable USB device
to the B port on the unit.
6 Press "/1 to turn off the system.
To activate or check the timer again
Unit:
Press REC TIMER, turn OPERATION
DIAL until “REC SELECT” appears, and
then press ENTER.
RM-AMU053:
Press CLOCK/TIMER SELECT, press
./> repeatedly until “PLAY
SELECT” or “REC SELECT” appears,
and then press ENTER.
RM-AMU054:
Press TIMER MENU to select “TIMER
SELECT”, then press . Press
v/V
repeatedly until “PLAY SELECT” or
“REC SELECT” appears, and then
press .
To cancel the timer
Repeat the same procedure as above until
“TIMER OFF” appears, and then press
ENTER (RM-AMU053 or on the unit) or
(RM-AMU054).
To change the setting
Start over from step 1.
Tips
• The system turns on before the preset time. If
the system is turned on at the preset time or if
“STANDBY” flashes in the display, the Play
Timer and the Recording Timer will not play
or transfer.
• The Play Timer setting remains as long as the
setting is not canceled manually.
• The volume is reduced to minimum during the
Recording Timer.
• The Recording Timer is canceled
automatically after the Recording Timer has
been activated.
• The Play Timer may not be activated
depending on the status of the connected iPod.
• Be sure that the iPod is not playing when
using the Play Timer.