Filter
Top Products
22
1 Place CDs and close the front cover.
2 Press FUNCTION repeatedly until
“CD” appears in the display.
3 Press PLAY MODE repeatedly until
“PROGRAM” appears in the
display.
4 Press DISC SKIP to select a CD.
5 Turn the jog dial until the desired
track appears in the display.
6 Press PLAY MODE once.
The track is programmed. First “STEP”
and the programmed playing order
appear, then the total playing time
appears.
Wide display
Disc number
Normal display
Disc number
Total playing time
Track number
Track number
Total playing time
Wide display
Normal display
The last programmed track
Total playing timeThe last programmed track
Total playing time
Press
CHECK on the remote
repeatedly. After the
last track, “CHECK
END” appears.
CLEAR on the remote
in stop mode.
CHECK on the remote
repeatedly until the
number of the track to
be cleared lights up,
then press CLEAR.
1 Press DISC SKIP to
select a CD.
2 Turn the jog dial to
select a track.
3 Press PLAY MODE.
p once in stop mode or
twice while playing.
7 Repeat steps 4 through 6 to program
additional tracks.
Skip step 4 to select tracks from the same
disc.
8 Press ·P.
All the tracks play in the order you
selected.
To cancel Program Play
Press PLAY MODE repeatedly until
“PROGRAM,” “ALL DISCS SHUFFLE,” or
“1 DISC SHUFFLE” disappears from the
display.
To
Check the program
Clear the last selected
track
Clear a specific track
Add a track to the
program
Clear the entire
program
Tips
• The program you created remains in the CD
player’s memory even after it has been played.
Press ·P to play the same program again.
• If “--.--” appears instead of the total playing time
while programming, this means:
– you have programmed a track numbered over
20, or
– the total playing time has exceeded 100 minutes.
Programming CD tracks
(continued)