Filter
Top Products
25
GB
HT-SL7A 4-235-541-42(3) GB
Additional Information
Additional Information
Precautions
On safety
Should any solid object or liquid fall into the cabinet,
unplug the amplifier and have it checked by qualified
personnel before operating it any further.
On power sources
• Before operating the unit, check that the operating
voltage is identical with your local power supply.
The operating voltage is indicated on the nameplate
at the rear of the amplifier.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the amplifier itself has been turned
off.
• If you are not going to use the amplifier for a long
time, be sure to disconnect the amplifier from the
wall outlet. To disconnect the AC power cord,
grasp the plug itself; never pull the cord.
• AC power cord must be changed only at the
qualified service shop.
On heat buildup
Although the unit heats up during operation, this is
not a malfunction. If you continuously use this unit at
a large volume, the cabinet temperature of the top,
side and bottom rises considerably. To avoid burning
yourself, do not touch the cabinet.
On placement
• Place the amplifier in a location with adequate
ventilation to prevent heat buildup and prolong the
life of the amplifier.
• Do not place the amplifier near heat sources, or in a
place subject to direct sunlight, excessive dust or
mechanical shock.
• Do not place anything on top of the cabinet that
might block the ventilation holes and cause
malfunctions.
• Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloraion of the
surface may result.
On operation
Before connecting other components, be sure to turn
off and unplug the amplifier.
On cleaning
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any question or problem concerning your
amplifier, please consult your nearest Sony dealer.
Troubleshooting
If you experience any of the following
difficulties while using the amplifier, use this
troubleshooting guide to help you remedy the
problem. Also, see “Checking the connections”
on page 18 to verify that the connections are
correct. Should any problem persist, consult
your nearest Sony dealer.
There is no sound no matter which component
is selected.
• Check that both the amplifier and all components
are turned on.
• Check that the MASTER VOLUME control is
not set at “MIN”.
• Check that all speaker cords are connected
correctly.
• Press MUTING to cancel the muting function.
• Check that the headphones are not connected to
the PHONES jack. No sound will come from the
speakers if the headphones are connected.
• Check that the amplifier is not in “Demonstration
Mode” (see page 2).
There is no sound from a specific component.
• Check that the component is connected correctly
to the audio input jacks for that component.
• Check that the cord(s) used for the connection is
(are) fully inserted into the jacks on both the
amplifier and the component.
continued
Other Operations/Additional Information