Filter
Top Products
masterpage:Right
lename[E:\SEM_Janet\Revision_HTP-
200\J9040000_2103636121HTP1200CEL\2103636121\GB08REM_HTP-1200-CEL.fm]
model name1[HTP-2000]
model name2[HTP-1200]
[2
-
103
-
636
-
12
(1)]
33
GB
Operations Using the Remote RM-U700
Notes
• The AUX button on the remote is not available for
receiver operation.
• When you press the input buttons (VIDEO, DVD),
the input mode of the TV might not switch to the
corresponding input mode that you want. In this case,
press the TV/VIDEO button to switch the input mode
of the TV.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described
.
If the factory settings of the input buttons do not
match your system components, you can change
them. For example, if you have a CD player and
you do not have a DVD player, you can assign
the DVD button to your CD player.
1 Hold down the input button whose
input you want to change (for example,
DVD).
2 Press the corresponding button of the
component you want to assign to the
input button (for example, 1 – CD
player).
The following buttons are assigned to select
the input:
*Sony VCRs are operated with a VTR 2 or 3
setting. These correspond to 8mm and VHS
respectively.
Now you can use the DVD button to control
the CD player.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input buttons to
their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the
same time.
Remote
Button
Operations Function
./>
7
VCR/
CD player/
DVD player
Skips tracks.
m/M
8
CD player/
DVD player
Searches tracks in the
forward or backward
direction.
VCR Fastforwards or rewinds.
H 9 VCR/
CD player/
DVD player
Starts playblack.
X q; VCR/
CD player/
DVD player
Pauses playblack or
record. (Also starts
recording with
components in recording
standby.)
x w; VCR/
CD player/
DVD player
Stops playback.
Changing the factory
setting of an input button
To operate Press
CD player 1
VCR (command mode VTR 2*) 2
VCR (command mode VTR 3*) 3
DVD player 4
TV 5
DSS (Digital Satellite Receiver) 6
Tuner (this receiver) 7
DCS (Digital CS Tuner) 8
BSD (Digital BS Tuner) 9
Tuner (Component tuner) 0/10
GB01COV_HTP-1200-CEL.book Page 33 Thursday, September 23, 2004 6:22 PM