Filter
Top Products
masterpage:Left
lename[E:\SEM_Janet\Revision_SF800M\J9050000_2592136121SF800M_GB\2592136121\G
B
08REM_HT-SF800M-CEL.fm]
model name [HT-SS600/HT-SF800M]
[2-592-136-12(1)]
34
GB
Notes
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• When you press input buttons (VIDEO 1, VIDEO 2
or DVD), the input mode of the TV might not switch
to the corresponding input mode that you want. In
this case, press TV/VIDEO button to switch the input
mode of the TV.
• To activate the buttons with orange printing, press
TV and the button you want simultaneously.
.
If the factory settings of the input buttons do not
match your system components, you can change
them. For example, if you have a CD player and
you do not have a DVD player, you can assign
the DVD button to your CD player.
1 Hold down the input button whose
input you want to change (for example,
DVD).
2 Press the corresponding button of the
component you want to assign to the
input button (for example, 5 – CD
player).
The following buttons are assigned to select
the input:
*Sony VCRs are operated with a VTR 2 or 3
setting. These correspond to 8 mm and VHS
respectively.
Now you can use the DVD button to control
the CD player.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input buttons to
their factory setting
Press ?/1, TEST TONE and MASTER VOL –
at the same time.
Remote
Button
Operations Function
X ws VCR/
CD player/
DVD player/
MD deck/
Tape deck
Pauses playback or
recording. (Also starts
recording with
components in
recording standby.)
x w; VCR/
CD player/
DVD player/
MD deck/
Tape deck
Stops playback.
O wj DVD player Returns to the
previous menu or
exits the menu.
V/v wk Receiver Selects a menu item.
B/b wk Receiver Adjusts or changes
the setting.
V/v/B/b wk VCR/
Satellite tuner/
DVD player
Selects a menu item.
Changing the factory
setting of an input button
To operate Press
VCR (command mode VTR 3*) 1
VCR (command mode VTR 2*) 2
DVD player or
DVD recorder
(command mode DVD 1)
3
DVD recorder
(command mode DVD 3)
4
CD player 5
MD deck 6
Tape deck B 7
Tuner (this receiver) 8
DSS (Digital Satellite Receiver) 9
DCS (Digital CS Tuner) 0/10
BSD (Digital BS Tuner) -/--
GB01COV_HT-SF800M-CEL.book Page 34 Monday, March 28, 2005 4:03 PM