Filter
Top Products
6
GB
D:\Chin Meng's job\SONY-HA\HT-SF1200_R2\1200_data\3210767121\GB03CON_HT-SF1200-
CEL.fm
masterpage: Left
[HT-SF1200/HT-SS1200]
3-210-767-12
(2)
About the indicators on the display
L
CR
SL SR
SW
D.RANGE
RDS
ST MONO
MEMORY
S
DIGITAL
DTS
HDMI
PL
OPT
COAX
21 3 4 5 6 7
8
9q
;
q
a
q
s
q
d
q
f
SLEEP
LFE
Name Function
ALFE Lights up when the disc being
played back contains an LFE
(Low Frequency Effect) channel
and the LFE channel signal is
actually being reproduced.
BSLEEP Lights up when the sleep timer is
activated (page 56).
CPlayback
channel
indicators
L
R
C
SL
SR
S
The letters (L, C, R, etc.) indicate
the channels being played back.
The boxes around the letters vary
to show how the receiver
downmixes the source sound.
Front Left
Front Right
Center (monaural)
Surround Left
Surround Right
Surround (monaural or the
surround components obtained
by Pro Logic processing)
Example:
Recording format (Front/
Surround): 3/2.1
Sound Field: A.F.D. AUTO
D;
DIGITAL Lights up when receiver is
decoding Dolby Digital signals.
Note
When playing a Dolby Digital
format disc, be sure that you
have made digital connections.
EHDMI Lights up when a playback
component is connected to this
receiver using a HDMI jack
(page 19).
FPreset
station
indicators
Lights up when using the
receiver to tune in radio stations
you have preset. For details on
presetting radio stations, see
page 49.
L
CR
SL SR
SW
Name Function
GD.RANGE Lights up when dynamic range
compression is activated (page
33).
HTuner
indicators
Lights up when using the
receiver to tune in radio stations
(page 47), etc.
IMEMORY Lights up when a memory
function, such as Preset Memory
(page 49), etc., is activated.
JCOAX Lights up when IN MODE is set
to “AUTO IN” and the source
signal is a digital signal being
input through the COAX IN
jack, or when IN MODE is set to
“COAX IN” (page 52).
KOPT Lights up when IN MODE is set
to “AUTO IN” and the source
signal is a digital signal being
input through the OPT IN jack,
or when IN MODE is set to
“OPT IN” (page 52).
L;PL(II) “; PL” lights up when the
receiver applies Pro Logic
processing to 2 channel signals
in order to output the center and
surround channel signals.
“; PLII” lights up when the
Pro Logic II Movie/Music
decoder is activated.
MDTS Lights up when the receiver is
decoding DTS signals.
Note
When playing a DTS format
disc, be sure that you have made
digital connections.
NSW Lights up when the audio signal
is output from the
SUBWOOFER jack.