Filter
Top Products
20
GB
Hooking Up and Setting Up the Speaker System
There is no sound no matter which component is
selected.
, Check that both the amplifier and all components
are turned on.
, Check that the volume level on the display is not
set to VOL MIN by turning the MASTER
VOLUME.
, Check that all speaker cords are connected
correctly.
, Press MUTING on the remote to turn off the
MUTING function.
There’s no sound from a specific component.
, Check that the component is connected correctly to
audio input jacks for that component.
, Check that the cord(s) used for the connection is
(are) fully inserted into the jacks on both the
amplifier and the component.
If you encounter a problem that is not included above, see
“Troubleshooting” on page 34.
Function buttons
Checking the connections
After connecting all of your components to the amplifier,
do the following to verify that the connections were made
correctly.
1 Press ?/1 to turn on the amplifier.
2 Press a function button to select a component
(program source) that you connected (e.g., VIDEO,
TV).
3 Turn on the component and start playing it.
4 Rotate MASTER VOLUME to turn up the volume.
If you do not obtain normal sound output after
performing this procedure, look for the reason in the
checklist on this page and take the appropriate measures
to correct the problem.
Before You Use Your Amplifier
?/1 MASTER VOLUME
R
?/1
VIDEO TV DVD AUX 5.1CH/SAT
SURR LEVEL SET UP
+–
SOUND FIELD MODE
MASTER VOLUME
–+