Filter
Top Products
8
EN
Actual total number: SONY EXCD-31 (E) 3-810-609-11(1)
Tuning in by Adjusting the
Frequency
— Manual Tuning
1 Select the desired band (page 7).
2 Press and hold either side of the SEEK/
AMS/MANU button.
Release the button when the desired station
is received.
PREVENT ACCIDENTS!
When tuning in during driving, use automatic
tuning.
Memorizing Stations
Automatically
— Automatic Memory Function
Stations with the clearest reception are
automatically searched and memorized on
each band (FM I, FM II, FM III, and AM). Up to
6 stations on each band can be stored on the
preset number buttons 1 to 6 in the order of
band frequency.
1 Select the desired band (page 7).
2 Press the
A.MEM
button for more than two
seconds.
The unit will be start scanning the selected
band and memorize the tuned stations on
the preset number button 1 through 6
automatically.
Memorizing Only the
Desired Stations
1 Select the desired band (page 7).
2 Tune in the station which you wish to
store on a preset number button.
3 Press and hold the desired preset
number button (
1
INTRO
to
6
) for about
two seconds until you hear a beep tone.
The number of the pressed preset number
button appears in the display window.
Up to 6 stations on each band (FM I, FM II, FM III and
AM) can be stored on the preset number buttons in the
order of your choice. Therefore, 18 stations can be
memorized on FM.
If you try to store another station on the same preset
number button, the previously stored station will be
erased.
Receiving the Memorized
Stations
1 Select the desired band (page 7).
2 Press momentarily the preset number
button (
1
INTRO
to
6
) on which the
desired station is stored.
Note
If you press the preset number button for more than two
seconds, the currently received station will be memorized.
To receive the previously memorized station, make sure
that the preset number button is pressed only momentarily.
For lower frequencies For higher frequencies
MANU
SEEK/AMS
MANU
SEEK/AMS