Filter
Top Products
61
Settings and Adjustments
Adjusting the speaker volume
1 After you stop playback, select “SPEAKER SETUP”
in the setup display.
2 Select “TEST TONE” and set “TEST TONE” to “ON.”
You will hear the test tone from each speaker in
sequence.
3 From your listening position, select “BALANCE” or
“LEVEL” and adjust the value of “BALANCE” using
</, and “LEVEL” using M/m.
The test tone is emitted from both left and right
speakers simultaneously.
4 Select “TEST TONE” and set “TEST TONE” to “OFF”
to turn off the test tone.
To adjust the volume of all the speakers at one
time
Use the receiver’s (amplifier’s) volume control.
Controlling Your TV or AV
Receiver (Amplifier) with
the Supplied Remote Z
By adjusting the remote signal, you can control your TV
or AV receiver (amplifier) with the supplied remote.
The default setting is to control Sony TVs with the g
mark.
Controlling TVs or AV receivers
(amplifiers) with the remote
Hold down TV ?/1, and enter your TV’s or AV
receiver’s manufacturer’s code (see the table on the
next page) using the number buttons. Then release TV
?/1.
Code numbers of controllable TVs or AV receivers
(amplifier)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV or AV receiver (amplifier).
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
TV
123
456
789
0
TV ?/1
Number
buttons