Filter
Top Products
12
Getting Started
If you have a digital component such as a
receiver (amplifier) with a digital connector, DAT
or MD
Connect the component via the DIGITAL OUTPUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
When you play a DVD, set “DIGITAL OUT” in “AUDIO SETUP”
to “ON” and then set “DOLBY DIGITAL” to “D-PCM,“ “MPEG”
to “PCM” and “DTS” to “OFF” in the setup display (page 67).
pWhen using an optical digital connecting cord
pWhen using a coaxial digital connecting cord
Notes
• Refer to the instructions supplied with the component to be
connected.
• You cannot make digital audio recordings of discs recorded in
multichannel surround format directly using an MD deck or
DAT deck.
When you make the connections above, do not set
“DOLBY DIGITAL” to “DOLBY DIGITAL,” “MPEG” to
“MPEG” and “DTS” to “ON.” If you do, a loud noise
will suddenly come out from the speakers, affecting
your ears or causing the speakers to be damaged.
Optical digital connecting cord
(not supplied)
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
Coaxial digital connecting cord
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
If you have an audio component with a built-in
DTS decoder, Dolby Digital decoder or MPEG
decoder
Connect the component via the DIGITAL OUTPUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
p When you play a DVD that is recorded in DTS format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then
set “DTS” to “ON” in the setup display (page 67).
p When you play a DVD that is recorded in Dolby Digital
format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then
set “DOLBY DIGITAL” to “DOLBY DIGITAL” in the setup
display (page 67).
p When you play a DVD that is recorded in MPEG format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then
set “MPEG” to “MPEG” in the setup display (page 67).
Notes
• Refer to the instructions supplied with the component to be
connected.
• When you do not connect an audio component with a
built-in DTS decoder, do not set “DTS” to “ON.”
• When you do not connect an audio component with a built
in DOLBY DIGITAL decoder, do not set “DOLBY DIGITAL” to
“DOLBY DIGITAL.”
• When you do not connect an audio component with a built
in MPEG decoder, do not set “MPEG” to “MPEG.”
CD/DVD player
Audio component
with a built-in
DTS decoder,
DOLBY DIGITAL or
MPEG decoder
Optical or coaxial digital
connecting cord
Speakers
(not supplied)
OPTICAL COAXIAL
PCM/MPEG/DTS/
DOLBY DIGITAL
(
AC-3
)
DIGITAL OUTPUT
DIGITAL IN
OPTICAL
DIGITAL IN
COAXIAL
OPTICAL COAXIAL
PCM/MPEG/DTS/
DOLBY DIGITAL
(
AC-3
)
DIGITAL OUTPUT
Receiver (Amplifier) Hookups