Filter
Top Products
31
Hookups
• D-PCM (page 79)
• DOLBY DIGITAL (only if the
amplifier (receiver) has a Dolby Digital
decoder) (page 79)
13Press ENTER.
“DTS” is selected.
14Press X/x to select the type of
DTS signal sent to your amplifier
(receiver).
Choose the item that matches the audio
connection you selected on pages 25 to
27 ( through ).
• D-PCM (page 80)
• DTS (only if the amplifier (receiver)
has a DTS decoder) (page 80)
15Press ENTER.
◆ When “DIGITAL OUTPUT” is selected
in step qa
• Quick Setup is finished and
connections are complete.
For DVP-NS915V
• If your AV amplifier (receiver) has an
MPEG audio decoder, set “MPEG” to
“MPEG” (page 80).
◆ When “DIGITAL & 5.1CH OUTPUT” is
selected in step qa
• The Setup Display for “SPEAKER
SETUP” appears.
16Press X/x to select the size of the
center speaker.
If no center speaker is connected, select
“NONE” (page 81).
17Press ENTER.
“REAR” is selected.
18Press X/x to select the size of the
rear speakers.
If no rear speaker is connected, select
“NONE.”
“SIDE” and “REAR” refer to the speaker
position relative to your listening
position (page 81).
19Press ENTER.
“SUBWOOFER” is selected.
20Press X/x to select whether or
not you have connected a
subwoofer.
21Press ENTER.
Quick Setup is finished. All connections
and setup operations are complete.
B-2 C-2
D-2
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
OFF
STANDARD
AUDIO FILTER: SHARP
ON
DOWNMIX:
DOLBY SURROUND
D-PCM
D-PCM
48kHz/96kHz PCM:
DTS
DTS:
D-PCM
B D
B-2 C-2
D-2
SPEAKER SETUP
SIZE:
DISTANCE:
BALANCE:
LEVEL:
OFF
TEST TONE:
FRONT:
CENTER:
SMALL
LARGE
NONE
LARGE
REAR:
SUBWOOFER:
To set
,
p
ress
,
then .
ENTER
NONE
SPEAKER SETUP
SIZE:
DISTANCE:
BALANCE:
LEVEL:
OFF
TEST TONE:
FRONT:
CENTER:
LARGE
REAR:
SUBWOOFER:
NONE
LARGE(REAR)
NONE
LARGE
SPEAKER SETUP
SIZE:
DISTANCE:
BALANCE:
LEVEL:
OFF
TEST TONE:
FRONT:
CENTER:
LARGE
LARGE
REAR:
SUBWOOFER:
To set, press , then .
To quit press
ENTER
SETUPDISPLAY
NONE
NONE
YES
LARGE(REAR)
,continued