Filter
Top Products
1-1
CU-F780/G780/E700/E672/F117
Section 1
Operating Instructions
Reprinted from the
operating instructions
CU-F780
CU-G780
CU-E700
CU-E672
CU-F117
Operating Instructions
3-205-156-02 (1)
Sony Corporation © 2000
Printed in Japan
Capsule Unit
Mounting on the transmitter
Turn the capsule unit in the direction of the arrow as shown below.
Be sure to securely mount the capsule unit on the transmitter.
on the
example.
Transmitter WRT-847A/847B
Microphone capsule unit
In the figure, the CU-F780 capsule unit is mounted
WRT-847A/847B transmitter (optional) as an
B CU-G780
ø51
ø37
90
Dimension: unit in mm
Mass:180g
ø51
ø37
98
C CU-E700
Dimension: unit in mm
Mass:170g
ø44
ø37
105
ø24
ø37
172
Dimension: unit in mm
Mass:150g
Dimension: unit in mm
Mass:170g
E CU-E672
E CU-F117
ø51
ø37
90
Dimension: unit in mm
Mass:180g
A CU-F780
English
The CU-F780/CU-G780/CU-E700/CU-E672/CU-F117 are the
Microphone Capsule Units designed for the WRT-847A/WRT-
847B Sony UHF synthesized transmitter unit to be used in a Sony
UHF synthesized wireless microphone system.
Specifications
Type CU-F780 / CU-G780 / CU-F117
Dynamic microphone capsule
CU-E700 / CU-E672
Electret condenser microphone
capsule
Frequency response CU-F780 : 50 Hz to 18,000 Hz
CU-G780: 50 Hz to 20,000 Hz
CU-E700 : 50 Hz to 18,000 Hz
CU-E672 : 50 Hz to 16,000 Hz
CU-F117 : 50 Hz to 15,000 Hz
See frequency response curves on the other
side of the sheet.
Directivity CU-F780 / CU-G780 / CU-E700 :
Uni-directional (Super cardioid)
CU-E672 :
Uni-directional (Hyper cardioid)
CU-F117 :
Omni-directional
See direcivity curves on the other side of
the sheet.
Sensitivity CU-F780 : –55 dB (1.78 mV)
CU-G780: –55 dB (1.78 mV)
CU-E700 : –55 dB (1.78 mV)
CU-E672 : –45 dB (5.62 mV)
CU-F117 : –52 dB (2.51 mV)
(0 dB= 1V/Pa, 1kHz)
General
Dimensions and mass See figures A to E.
Operating temperature
0 °C to +50 °C (+32 °F to +122 °F)
Storage temperature –20 °C to +60 °C (–4 °F to +140 °F)
Supplied accessories
Operating Instructions (1)
Wind screen (supplied only for CU-E672 / CU-F117) (1)
Design and specifications are subject to change without notice.