Filter
Top Products
CMT-BX3.GB.3-095-504-21(1)
23
GB
Others
Play does not start from the rst
track.
Set the play mode to Normal Play
mode.
Files cannot be played back.
USB storage media formatted with le
systems other than FAT16 or FAT32
are unsupported.*
If you use partitioned USB storage
media, only les on the rst partition
can be played.
Files that are encrypted or protected by
passwords, etc. cannot be played back.
* is system supports FAT16 and FAT32, but
some USB storage media may not support all
of these FAT. For details, see the operation
manual of each USB storage media or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
ashes on the display.)
Connect the antenna properly.
Find a location and an orientation that
provide good reception, and then set
up the antenna again.
Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
Connect a commercially available
external antenna.
Consult your nearest Sony dealer if the
supplied AM antenna has come o the
plastic stand.
Turn o nearby electrical equipment.
To change the AM tuning interval
e AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas; this
function is not available on the European
model).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn o the system.
2
While holding down TUNER/BAND
, press /
.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
To improve tuner reception
Turn o CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION
repeatedly to
select the CD function, and then turn
o the system.
2
After “STANDBY” stops ashing, press
/
on the unit while holding
down /CANCEL
on the unit.
“CD POWER OFF” appears. With CD
player power turned o, disc access
time is increased. To turn on CD
player power, repeat the procedure
until “CD POWER ON” appears.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press
, /CANCEL
and
/
at the same time.
All user-congured settings, such as
preset radio stations, timer, and the
clock, are deleted.