Filter
Top Products
Tuner
11
GB
Other Operations
To
Tune in a station with a
weak signal
Change the preset
number
Set another station to
an exsisting preset
number
To change the AM tuning interval
(except for the European and Middle
Eastern models)
Disconnect the power cord from the wall outlet
first, and then set the AM FREQ STEP switch
at the rear to 9 kHz or 10 kHz.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 10).
1 Press TUNER (TUNER/BAND on the
remote).
2 Press PRESET + or – repeatedly to tune
in the desired preset station.
The preset number appears in the display
for a few seconds.
When only one station is preset, only that
station is tuned.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER (TUNER/BAND on the
remote) repeatedly to select “FM” or
“AM”.
2 Turn TUNING +/– (or press TUNING + or
– on the remote) repeatedly to tune in
the desired station.
Tip
To improve broadcast reception, adjust the antenna
(for FM) or reorient the main unit itself (for AM).
Do this
Follow the procedure
described in “Setting
presets through manual
tuning”.
Start over from step 1.
Start over from step 1.
After step 3, press
PRESET + or –
repeatedly to select the
preset number where you
want to store the other
station and then press
ENTER/PGM (TUNER
MEM/ENTER/PGM on
the remote).