Filter
Top Products
19
Adjusting setup items
1 Press and hold the select button.
The setup display appears.
2 Rotate the control dial until the desired
item appears, then press it.
3 Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4 Press (BACK).
* For CLOCK-ADJ, TUNER-STP and BTM
settings, step 4 is not necessary.
The following items can be set depending
on the source and setting:
CLOCK-ADJ (Clock Adjust) (page 4)
TUNER-STP*
1
*
3
(Tuner Step) (page 4)
CT (Clock Time)
Activates the CT function: “ON,” “OFF”
(page 10).
BEEP
Activates the beep sound: “ON,” “OFF.”
CAUT ALM*
3
(Caution Alarm)
Activates the caution alarm: “ON,”
“OFF” (page 5).
AUX-A*
3
(AUX Audio)
Activates the AUX source display: “ON,”
“OFF” (page 20).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: “NO,”
“30S (Seconds),” “30M (Minutes),” “60M
(Minutes).”
REAR/SUB*
3
Switches the audio output: “SUB-OUT”
(subwoofer), “REAR-OUT” (power
amplifier).
BLK OUT (Black Out)
Turns off the illumination automatically
for any source (e.g., during radio
reception/CD playback, etc.) if no
operation is performed for 5 seconds:
“ON,” “OFF.”
To bring the light back on, press any
button on the unit. (When activated,
remote operation is unavailable.)
DEMO
(Demonstration)
Activates the demonstration: “ON,”
“OFF.”
DIMMER
Changes the display brightness: “ON,”
“OFF.”
ILLUM*
2
(Illumination)
Changes the illumination color: “1,” “2.”
M.DISPLAY (Motion Display)
– “SA”: to show moving patterns and
spectrum analyzer.
– “OFF”: to deactivate the Motion Display.
AUTO SCR (Auto Scroll)
Scrolls long items automatically: “ON,”
“OFF.”
ZAP TIME (Zappin Time)
Selects the playback time for the
ZAPPIN function.
– “Z.TIME-1 (about 6 seconds),”
“Z.TIME-2 (about 15 seconds),”
“Z.TIME-3 (about 30 seconds).”
ZAP BEEP (Zappin Beep)
Has the beep sound between track
passages: “ON,” “OFF.”
LPF FREQ*
4
(Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
“50Hz,” “60Hz,” “80Hz,” “100Hz,”
“120Hz.”
LPF SLOP*
4
(Low Pass Filter Slope)
Selects the LPF slope: “1,” “2,” “3.”
SW PHASE*
5
(Subwoofer Phase)
Selects the subwoofer phase: “NORM,”
“REV.”