Filter
Top Products
27
Error displays/Messages
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car’s aerial booster.
(Only when your car has built-in FM/AM
aerial in the rear/side glass.)
• Check the connection of the car aerial.
• The auto aerial will not go up.
tCheck the connection of the power aerial
control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
tSet the DSO mode to “OFF” (page 22).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
tSet the local seek mode to “OFF”
(page 15).
• The broadcast signal is too weak.
tPerform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet the monaural reception mode to
“ON” (page 16).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode
(page 16).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK*
1
No tracks have been recorded on an MD.*
2
tPlay an MD with recorded tracks on it.
ERROR*
1
• A CD is dirty or inserted upside down.*
2
tClean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.
tInsert another CD/MD.
FAILURE
The connection of speakers/amplifier is
incorrect.
tSee the installation guide manual of this
model to check the connection.
HI TEMP
The ambient temperature is more than 50°C.
tWait until the temperature goes down
below 50°C.
NO DISC
No disc is inserted in the CD/MD unit.
tInsert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD
unit.
tInsert the magazine in the CD unit.
continue to next page t