Filter
Top Products
26
EN
Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
You can store the bass and treble levels
independently for each source.
1 Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n SUB (subwoofer volume)
n BAS (bass) n TRE (treble)
n BAL (left-right) n FAD (rear-front)
2 Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
function reverts volume control.)
Attenuating the sound
Press (ATT) on the rotary commander or
optional wireless remote.
“ATT on” flashes momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
The unit decreases the volume automatically when
a telephone call comes in (Telephone ATT
function).
Changing the sound and
display settings
The follow items can be set:
• Clock (page 7).
•CT (Clock Time) (page 21).
• D.Info (Dual Information) - to display the
clock and the play mode at the same time
(ON) or to display the information
alternately (OFF).
• Amber/Green - to change the illumination
colour to amber or green.
• Dimmer - to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.
• Contrast - to adjust the contrast if the
indications in the display are not
recognisable because of the unit’s installed
position.
•Voice guide function for vocalised comments.
— Select “Voice 1” to minimise the volume
of the guide.
— Select “Voice 2” to be louder the volume
than “Voice 1.”
— Select “Voice 3” to maximise the volume
of the guide.
— Select “Voice off” to deactivate Voice
guide.
• Beep - to turn on or off the beeps.
• RM (Rotary Commander) - to change the
operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary
commander as the factory-set position.
— Select “rev” when you mount the rotary
commander on the right side of the
steering column.
• Loud (Loudness) - to enjoy bass and treble
even at low volume. The bass and treble will
be reinforced.
•LPF (Low Pass Filter) (page 27)
• A.Scrl (Auto Scroll) (pages 9, 28)
1 Press (SHIFT).
2 Press (3) (SET UP) repeatedly until the
desired item appears.
Each time you press (3) (SET UP), the item
changes as follows:
Clock n CT n D.Info* n Amber/Green n
Dimmer n Contrast n Voice* n Beep n RM
n Loud* n LPF* n A.Scrl*
* When you have not tune the station or there
is no CD/MD being played, these items will
not appear.
Note
The displayed item will differ depending on
the source.
3 Press (5) (n) to select the desired
setting (for example: on or off).
For the “Contrast” setting, pressing (5)
(n) makes the contrast higher, and
pressing (2) ( N) makes the contrast lower.
4 Press (SHIFT).
After the mode setting is complete, the
display returns to normal playback mode.