Filter
Top Products
22
EN
Adding tracks to a program
1 Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
“P 1” shows Program 1 is selected.
If you have labeled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display “P 1” above.
To select Program 2, press (5) (n)
repeatedly until “P 2” appears.
2 Press (2) (N) or (5) (n) to select the
track slot number where you want to
insert a track.
3 Push the SEEK/AMS control up or down
to select the track you want to insert.
4 Press (6) (ENTER) momentarily to enter
the track.
The current track in that slot number and
the succeeding tracks shift down.
To continue inserting tracks, repeat steps 2
through 4.
Note
Once all 12 slots have been filled,
“*Mem Full*” appears in the display, and you
cannot insert tracks.
5 When you finish inserting tracks, press
(4) (PLAY MODE) for two seconds.
6 Press (SHIFT).
Track slot number
PLAY
DISC TRACK
MODE ENTER
PLAY
DISC TRACK
MODE ENTER
Erasing an entire program
1 Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
“P 1” shows Program 1 is selected.
If you have labeled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display “P 1” above.
2 Press (2) (N) repeatedly until “DEL”
appears.
To erase Program 2, press (5) (n)
repeatedly until “PGM 2” appears.
3 Press (6) (ENTER) for two seconds.
The entire program is erased.
4 When you finish erasing programs, press
(4) (PLAY MODE) for two seconds.
5 Press (SHIFT).
PLAY
DISC TRACK
MODE ENTER
PLAYMODE ENTER
PLAYMODE ENTER