Filter
Top Products
18
Error displays/Message
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster.
(Only when your car has built-in FM/AM
antenna in the rear/side glass.)
• Check the connection of the car antenna.
• The auto antenna will not go up.
tCheck the connection of the power
antenna control lead.
• Check the frequency.
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
tSet the local seek mode to “OFF”
(page 11).
• The broadcast signal is too weak.
tPerform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet the monaural reception mode to
“ON” (page 11).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode
(page 11).
Error displays
The following indications will flash for about 5
seconds (and in the case of “Err04”, an alarm
will be heard).
Err04
A CD is dirty or inserted upside down.
tClean or insert the CD correctly.
Err50
The connection of speakers/amplifiers is
incorrect.
tSee the installation guide manual of this
model to check the connection.
Err60
There may be an internal malfunction.
tCheck the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
Err99
The CD unit cannot be operated because of
some problem.
tPress the RESET button on the unit.
Message
“” or “”
You have reached the beginning or the end of
the disc and you cannot go any further.