Filter
Top Products
16
Changing the sound and
display settings
The following items can be set:
SET (setting)
•CLOCK (page 8)
•BEEP — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select “NORM” to use the rotary
commander as the factory-set position.
— Select “REV” when you mount the rotary
commander on the right side of the
steering column.
DIS (display)
•D.INFO (Dual Information) — to display the
clock and the play mode at the same time
(ON).
•M.DSPL (Motion Display) — to turn the
motion display on or off.
•A.SCRL (Auto Scroll) (page 10)
Note
If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be disabled.
1 Press (MENU).
2 Press either side of (PRST) epeatedly until
the desired item appears.
Each time you press the (–) side of
(PRST), the item changes as follows:
CLOCK t BEEP t RM t D.INFO t M.DSPL
t A.SCRL
Note
The displayed item will differ depending on
the source.
Tip
You can easily switch among categories (“SET”,
“DIS”, “P/M” (play mode), and “EDT” (edit
mode)) by pressing either side of (PRST) for
two seconds.
3 Press the (+) side of (SEEK/AMS) to select
the desired setting (Example: ON or OFF).
4 Press (ENTER).
After the mode setting is complete, the
display returns to normal play mode.
Boosting the bass sound
— D-bass
You can enjoy a clear and powerful bass
sound.
The D-bass function boosts the low and high
frequency signal with a sharper curve than
conventional bass boost.
You can hear the bass line more clearly even
while the vocal volume remains the same. You
can emphasize and adjust the bass sound
easily with the D-BASS control.
0dB
D.BASS-3
D.BASS-2
D.BASS-1
D.BASS-3
D.BASS-2
D.BASS-1
Frequency (Hz)
Adjusting the bass curve
Press (D-BASS) repeatedly until the
desired bass level (1, 2, or 3) appears in
the display.
To cancel, select “D.BASS-OFF.”
Note
If the bass sound becomes distorted, select a less
effective setting of “D.BASS” or adjust the volume.
Level