Filter
Top Products
Playing CDs
14
GB
Last programmed
track
Playing order
Total playing time
Programmed
tracks
25
8
PROGRAM
MIN SEC
STEP
To select a track with a number over 10
Use the >10 button (see page 10).
If you’ve made a mistake
Press CLEAR, then press the correct track number.
3 Press · to start Programme Play.
To cancel Programme Play
Press CONTINUE.
You can check the total playing time while
programming using the remote (Programme Edit)
To select a track, press = or + and check the total
playing time. Then press PROGRAM to confirm your
selection.
When tracks which are not numerically consecutive
on the disc are programmed consecutively (i.e. 1, 3,
5 etc.)
A one-second access time blank is added between the
tracks.
The programme remains in memory even after
Programme Play ends
When you press ·, you can play the same programme
again.
Notes
• “––.––” appears instead of the total playing time in the
display when it exceeds 100 minutes.
• “FULL” appears in the display when you try to add a track
to a programme which already contains 24 tracks.
Notes
• “––.––” appears instead of the total playing time in the
display when it exceeds 100 minutes.
• “FULL” appears in the display when you try to add a track
to a programme which already contains 24 tracks.
Creating a programme using the remote
1 Press PROGRAM before you start playing.
“PROGRAM” appears in the display.
2 Press the number buttons of the tracks you want to
programme in the order you want.
Example: To programme the tracks 2, 8, and 5
Press the number buttons in order 2, 8,
and 5.
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK.
Each time you press this button, the display shows the
track numbers in the programmed order. After the last
track in the programme, the display shows “End” and
returns to the original display. If you check the order
after you start playing, the display shows only the
remaining track numbers.
Changing the track order
You can change your programme before you start
playing.
To
Erase a track
Erase the last track in the
programme
Add tracks to the end of
the programme
Change the whole
programme completely
You need to
Press CHECK until the undesired
track appears in the display, then
press CLEAR.
Press CLEAR. Each time you press
the button, the last track will be
cleared.
Turn ≠ AMS ± until the track
number you want to add appears,
then push ≠ AMS ±.
When using the remote, press the
number button of the track to be
added.
Hold down CLEAR until “ALL
CLr” appears in the display. Create
a new programme following the
programming procedure.