Filter
Top Products
AIR-SA20PK.GB.4-117-793-11(1)
28
GB
Using the sub units
When a radio station is tuned on the
main unit, you can listen to that station
by following the steps below.
To tune in a radio station using the sub
units, that station needs to be preset
beforehand (see “To call up a preset radio
station using the sub units” (page 29)).
1
Select the tuner channel.
Press S-AIR CH repeatedly until
“TUNER” appears in the display.
2
Select “FM” or “AM.”
Press and hold S-AIR CH until “FM”
changes to “AM” or vice versa.
To tune in a station with a weak signal
using the main unit
If “TUNED” does not appear and the
scanning does not stop, press TUNING
+/ on the remote (or TUNING/
SELECT +/ on the unit) repeatedly to
tune in the desired station.
To reduce static noise on a weak FM
stereo station using the main unit
1
Press SYSTEM MENU on the unit.
2
Press TUNING/SELECT +/ on the
unit repeatedly until “FM MODE”
appears, then press ENTER on the
unit.
3
Press TUNING/SELECT +/ on
the unit repeatedly until “MONO”
appears, then press ENTER on the
unit.
ere will be no stereo eect, but the
reception will improve.
Presetting radio
stations
You can preset your favorite radio
stations and tune them in instantly
by selecting the corresponding preset
number.
Use the main unit to preset the radio
stations.
1
Tune in the desired station.
See “Listening to the radio using the
S-AIR connection” (page 27).
2
Press SYSTEM MENU on the unit.
3
Press TUNING/SELECT +/
on the unit repeatedly until
“MEMORY” appears, then press
ENTER on the unit.
Preset number
4
Press TUNING/SELECT +/ on
the unit repeatedly to select
your desired preset number.
If another station is already assigned
to the selected preset number,
the station is replaced by the new
stations.